How to Do Dumbbell Rows: A Beginner’s Guide

Quick answer: To do a dumbbell row, place one hand and knee on a bench, keep your back flat, and let the dumbbell hang straight down. Pull the weight to your hip by driving your elbow back, pause briefly, then lower it slowly. Use a weight you can lift for 8–12 controlled reps without twisting or rounding your back.

The dumbbell row is one of the best beginner exercises for a stronger back, needing only a dumbbell and a bench. It trains the pulling muscles that pressing exercises leave behind. This guide covers the one-arm row in full, then the two-arm bent-over row. Our beginner dumbbell workout shows how rows fit into a full-body session.

What muscles do dumbbell rows work?

Rows mainly work the latissimus dorsi (the large muscles down the sides of your back), the rhomboids and trapezius between your shoulder blades, and the rear deltoids. Your biceps and forearms help pull, and your core keeps your torso still.

That makes the row a useful counterbalance to pushing exercises: if most of your training is push-ups and presses, your back lags behind. Our chest and back workout pairs the two sides together.

How do you do a dumbbell row with correct form?

Start with the one-arm row: a supported torso lets you focus on the pull. Use a light dumbbell while you learn the pattern, and add weight only once every rep looks the same.

One-arm dumbbell row, step by step

  1. Set up beside a bench. Place your left hand and left knee on a flat bench, right foot on the floor. Keep your back flat. Hold the dumbbell in your right hand, palm in, arm hanging straight down.
  2. Brace before you pull. Tighten your stomach, keep your shoulders level, and look at the floor ahead so your neck stays in line with your spine.
  3. Pull your elbow to your hip. Drive your elbow back, pulling the dumbbell to the side of your waist. Pull with your back, not your arm, keeping the dumbbell close to your body.
  4. Pause at the top. Pause, squeeze your shoulder blade towards your spine, and do not let your shoulder roll forwards.
  5. Lower slowly. Lower over two to three seconds, arm fully extended. The slow lowering is part of the exercise, not a rest.
  6. Finish one side, then switch. Finish all reps on one side before swapping, so the work stays even and you do not rush the weaker side.

See our guide to correct exercise form for more on good technique.

Two-arm bent-over dumbbell row

Once the one-arm row feels natural, try the two-arm version. Stand with feet hip-width apart, dumbbell in each hand, and hinge forwards until your torso is at roughly 45 degrees, knees slightly bent and back flat. Pull both dumbbells to your hips, elbows close, then lower with control. Start light, and stop if your lower back rounds.

What weight should a beginner start with?

Pick a dumbbell you can lift for 8–12 reps with good form, where the last two reps feel challenging but your technique stays the same. No single weight suits everyone.

As a rough starting point, most beginners start with a 5–10 lb (2–5 kg) dumbbell, some with 10–15 lb (5–7 kg). Twist or jerk it up and it is too heavy; finish 12 reps easily and it is too light.

Progress gradually: once you can complete all sets and reps with clean form for two sessions in a row, add the next smallest weight, or two reps per set.

How often should you do dumbbell rows?

For most beginners, two sessions a week is a good target, with at least one rest day between them. The NHS recommends strengthening activities for all major muscle groups on at least two days a week, and the CDC gives the same advice, alongside 150 minutes of moderate aerobic activity.

Rows fit a back or pull day, or a full-body session. On a split routine, place them on upper-body days — see our upper lower split for one way to organize the week.

Beginner dumbbell row workout

Week Sets x reps (each side) Rest between sets Notes
1–2 2 x 8 60–90 seconds Learn the form
3–4 3 x 8 60–90 seconds Add a third set
5–6 3 x 10 60 seconds Add reps first
7–8 3 x 12 60 seconds Move up in weight

Do this twice a week, in a session that also trains legs, chest and core. If form breaks down in the last set, stay at the same weight.

What are the most common dumbbell row mistakes?

Rounding your lower back. If your back rounds, the weight is too heavy. Stop, lighten the weight, and reset — a flat back protects your spine.

Twisting your torso. Keep your shoulders level. If your pulling shoulder rotates up, you are using momentum, not your back. Slow down and go lighter.

Jerking the weight up. A fast, swinging pull may move a heavier dumbbell, but it skips the part that builds strength. Pull under control, pause, and lower slowly.

Pulling to your chest. Pulling to your chest puts your shoulder in a weaker position. Aim your elbow for your hip, dumbbell close to your body.

Shortening the range. Let your arm fully extend at the bottom of each rep — half reps with a heavy weight do less than full reps with a lighter one.

Rushing the lowering phase. Dropping the weight wastes half the exercise. Lower over two to three seconds and stay in control.

Dumbbell row form checklist

Before every set:

  • ☐ Bench stable, will not slide
  • ☐ Hand and knee on bench, foot on floor
  • ☐ Back flat, like a tabletop
  • ☐ Neck in line, eyes on floor
  • ☐ Shoulders level, no twisting
  • ☐ Elbow drives to the hip
  • ☐ Pause and squeeze at the top
  • ☐ Lower slowly, two to three seconds
  • ☐ Breathe out pulling, in lowering

How can you progress dumbbell rows over time?

Once three sets of 12 reps feel comfortable, progress in one of three ways: add the smallest weight step, add a fourth set, or slow the lowering phase to three or four seconds. Change one thing at a time, and note your weight, sets and reps to track the trend.

Frequently asked questions

Are dumbbell rows good for beginners?

Yes. The one-arm version supports your torso on a bench, so you can learn the pull without worrying about balance. Start light, focus on a flat back and a slow lower, and add weight only when your form stays clean.

What is the difference between a one-arm row and a bent-over row?

The one-arm row uses a bench for support and trains one side at a time, so it is easier to learn and exposes a weaker side. The bent-over row works both sides at once and needs more core strength to hold the hinge. Start with the one-arm row.

How heavy should dumbbell rows be for a beginner?

Most beginners start with a 5–10 lb (2–5 kg) dumbbell, some with 10–15 lb (5–7 kg). The right weight lets you do 8–12 reps with good form, the last two feeling challenging. If you have to twist or jerk it up, go lighter.

Should my back be flat during dumbbell rows?

Yes. Your back should stay flat and roughly parallel to the floor, neck in line with your spine. If it rounds, the weight is too heavy or you are fatigued — stop, reduce the weight, and reset.

How many sets and reps of dumbbell rows should a beginner do?

Start with 2–3 sets of 8–12 reps on each side, twice a week, with 60–90 seconds of rest between sets. Build from 2 sets of 8 to 3 sets of 12 over several weeks, adding weight only when your form stays clean.

Do dumbbell rows work your biceps?

Yes, your biceps and forearms help, but the main muscles are the lats, rhomboids, trapezius and rear deltoids. If you mostly feel rows in your arms, pull your elbow to your hip and squeeze your shoulder blade at the top.


Written by the Fitness Daily Guide editorial team. This article is general fitness information for healthy beginners, not personal medical advice. If you have a health condition, an injury, or you have not exercised for some time, speak to your doctor before starting a new exercise routine. See our Disclaimer page for full details.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top